Bonjour,
J'ai acheté un patton SN 4970 en vue de "SIPé" mon T2 vers mon asterisk.
Sauf que quand je branche le T2 sur le port de la PATTON, rien ne se passe au niveau des LEDS d'une part et je ne peux ni émettre ni recevoir.
Voici ma conf :
Voyez-vous une grosse erreur ?Code:#----------------------------------------------------------------# # # # STARFACE configuration file # # for SN4970/4E30V/UI # # with Firmware R6.2 2012-11-12 H323 SIP BRI # # # #----------------------------------------------------------------# cli version 3.20 no terminal ssh administrator administrator password password clock local default-offset +01:00 dns-relay webserver port 80 language en system ic voice 0 low-bitrate-codec g729 system clock-source 1 e1t1 0 0 clock-source 2 e1t1 0 1 clock-source 3 e1t1 0 2 clock-source 4 e1t1 0 3 profile ppp default profile tone-set default profile voip default codec 1 g711alaw64k rx-length 20 tx-length 20 codec 2 g711ulaw64k rx-length 20 tx-length 20 profile voip pf_voip_starface codec 1 g711alaw64k rx-length 20 tx-length 20 no-silence-suppression dtmf-relay signaling default fax transmission 1 bypass g711alaw64k rx-length 20 tx-length 20 modem transmission 1 bypass g711alaw64k rx-length 20 tx-length 20 profile pstn default profile sip default no autonomous-transitioning profile aaa default method 1 local method 2 none context ip router rtp-port-range 10000 12399 interface if_eth0 ipaddress <ip patton> 255.255.254.0 tcp adjust-mss rx mtu tcp adjust-mss tx mtu interface if_eth1 ipaddress unnumbered context ip router route 0.0.0.0 0.0.0.0 <ip passerelle> 0 context cs switch national-prefix 0 international-prefix 00 routing-table called-e164 rt_sip_in route default dest-service hg_isdn cf_sip_normalize routing-table called-e164 rt_isdn_in route ..T3 dest-service hg_starface mapping-table calling-name to calling-pi mt_sip_a-clir map default to allowed map anonymous to restricted mapping-table calling-e164 to calling-numbering-plan mt_sip_a-numberingplan map default to isdn-telephony mapping-table called-e164 to called-numbering-plan mt_sip_b-numberingplan map default to isdn-telephony mapping-table calling-e164 to calling-type-of-number mt_sip_a-ton map (.%) to international map 0(.%) to national map 00(.%) to international map default to unknown mapping-table calling-e164 to calling-e164 mt_sip_a-e164 map 00(.%) to \1 map 0(.%) to \1 map default to "" map (.%) to \1 mapping-table calling-e164 to calling-e164 mt_sip_a-e164-localize map 0049(.%) to 0\1 mapping-table calling-e164 to calling-si mt_sip_a-screening map default to user-passed complex-function cf_sip_normalize execute 1 cf_sip_normalize-a execute 2 cf_sip_normalize-b complex-function cf_sip_normalize-a execute 1 mt_sip_a-e164-localize execute 2 mt_sip_a-clir execute 3 mt_sip_a-numberingplan execute 4 mt_sip_a-ton execute 5 mt_sip_a-e164 execute 6 mt_sip_a-screening complex-function cf_sip_normalize-b execute 1 mt_sip_b-numberingplan interface isdn if_isdn_pri0 route call dest-table rt_isdn_in no call-transfer accept no call-transfer emit address-complete-indication emit set interface isdn if_isdn_pri1 route call dest-table rt_isdn_in no call-transfer accept no call-transfer emit address-complete-indication emit set interface isdn if_isdn_pri2 route call dest-table rt_isdn_in no call-transfer accept no call-transfer emit address-complete-indication emit set interface isdn if_isdn_pri3 route call dest-table rt_isdn_in no call-transfer accept no call-transfer emit address-complete-indication emit set interface sip if_sip_starface bind context sip-gateway gw_sip_starface route call dest-table rt_sip_in remote <ip du starface> hold-method direction-attribute sendonly early-disconnect no call-transfer accept no call-transfer emit address-complete-indication accept set address-translation incoming-call calling-e164 from-header address-translation incoming-call calling-uri from-header address-translation incoming-call calling-name from-header use profile voip pf_voip_starface service hunt-group hg_starface drop-cause no-circuit-channel-available route call 1 dest-service sv_aaa_qos.if_sip_starface service hunt-group hg_isdn drop-cause resources-unavailable drop-cause circuit-channel-not-available route call 1 dest-service sv_aaa_qos.if_isdn_pri0 route call 2 dest-service sv_aaa_qos.if_isdn_pri1 service aaa sv_aaa_qos accounting start-trigger setup accounting use profile aaa default port if_isdn_pri0 route call dest-interface if_isdn_pri0 port if_isdn_pri1 route call dest-interface if_isdn_pri1 port if_isdn_pri2 route call dest-interface if_isdn_pri2 port if_isdn_pri3 route call dest-interface if_isdn_pri3 port if_sip_starface route call dest-interface if_sip_starface context cs switch no shutdown location-service ls_starface match-any-domain identity-group starface call outbound call inbound context sip-gateway gw_sip_starface interface gw_sip_if_starface bind interface if_eth0 context router port 5060 context sip-gateway gw_sip_starface no shutdown port ethernet 0 0 medium auto encapsulation ip bind interface if_eth0 router no shutdown port ethernet 0 1 medium auto encapsulation ip bind interface if_eth1 router no shutdown port e1t1 0 0 clock auto encapsulation q921 q921 permanent-layer2 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface if_isdn_pri0 switch port e1t1 0 0 no shutdown port e1t1 0 1 clock auto encapsulation q921 q921 permanent-layer2 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface if_isdn_pri1 switch port e1t1 0 1 no shutdown port e1t1 0 2 clock auto encapsulation q921 q921 permanent-layer2 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface if_isdn_pri2 switch port e1t1 0 2 no shutdown port e1t1 0 3 clock auto encapsulation q921 q921 permanent-layer2 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface if_isdn_pri3 switch port e1t1 0 3 no shutdown
Je dois avouer que j'y ai déjà passer quelques heures, mais je ne trouve pas.
Mon lien reste down :
Code:0DF2FA(cfg)#show port e1t1 0 0 E1T1 Port 0:0 ============= Administrative State: Up Port: e1 Linecode: hdb3 Framing: crc4 Application: short-haul LBO: 0-133 LOS Threshold: -46dB Encapsulation: q921 Clock: auto Operational State: Down Real clock: slave Loss of signal: true Frame sync: false Frame errors: false Out of frame errors: false Alarms: false Controlled slips: false BPV: 7500 EXZ: 148078249 LCV: 148085749 PCV: 0 CS: 6111
Répondre avec citation